External Programming Issue

Discussion in 'UDOO DUAL' started by Joe_Lowtech, Oct 13, 2017.

  1. Joe_Lowtech

    Joe_Lowtech New Member

    Joined:
    Oct 13, 2017
    Messages:
    1
    Likes Received:
    0
    Hello,
    I need some help with the external programming. The Udoo Board is working when i use the onboard Arduino IDE.
    But for some reason, the uploading of the sketch does not work correctly when im trying to load the Sketch from my pc.
    I can upload it once after shutting down the udoo but this is the only time it works. All the other times i get this error message:

    Output:
    No device found on COM10
    Sending auth and 0xF command
    /arduinoPlugin/packages/UDOO/tools/bossac-udoo/1.3a-1.0/bossac-udoo.exe finished
    upload done

    Im using the Sloeber IDE but i get the same error message with Arduino IDE.

    Any help on that matter is appreciated
    Regards
    Joe_Lowtech
     

Share This Page