I just found out that if I power my udoo before powering my screen, I have no output video.
My udoo is on Debian 9.1
Is there a way to...
Thanks ! what about knowing if the udoo is asleep or awake ? Is it possible to know that in the arduino sketch ?
Thanks for the answer, that's very useful.
If a programm is running (like a web page) on the Udoo and the arduino forces to sleep then wake it up....
I have seen the post : https://www.udoo.org/forum/threads/wake-and-sleep-via-arduino-101.9237/
I am using linux, do I just need to do...
I already did it, I unplugged the RTC battery, the power and all the devices.
I let the board rest during one night and tried the other day but...
I tried pressing ESC but nothing happenned and I still have no video output on the screen
I am having an issue with my udoo x86.
I was uploading a sketch to the arduino 101 and I accidently switch off the power.
When I powered...
Thanks for your help, yes I think I can use the code from here :
It's to connect the x86 to an mbed through UART.
And make the x86 send data to the mbed with the UART autonomously.
Like if the mbed send a...
Thanks for your answer, hovewer it uses another software I would like to be able to code and compile a file to communicate.
I have seen this website : http://www.geduino.org/site/archives/284
It explains how to send data from an arduino to the udoo x86.
I solved my issue it was just a bad wiring :)
I am wondering if my arduino 101 is dead. I power my udoo x86 and detect the arduino 101 with the arduino IDE. I can send code and use the...
I am in the same situation, the led is orange and when I put a cable to a screen nothing happens, the screen stays black
According to this :
It's possible to programm...
When I power my Udoo x86 there is a led flashing from green to orange.
I noticed that it's doing it until I reach 12,4 V. Also below 12,4V...
Oh okay I understand.
The intel Curie seems to draw very few current.
These 36 W are measured when the arduino 101 is also running at its maximum ?
Because I would like to know if both processors are under stress...
In the manual it is adviced to power the UDOO X86 with 36W and 12V DC. But in the consommation table, the needed current seems to be at...
Thanks for the explanation
Could you indicate me where is the starting potential of the power jack before all the various components to produce...
Separate names with a comma.