The Udoo Neo doc pages in Power Management have: Power sources You can power up the board in 3 ways DC-jack: internal positive, Voltage 6 to...
I want to program the Neo M4 from my Mac (El Capitan) using the Arduino IDE v1.6.9 over the network. So, I followed these directions...
The below code to detect I2C devices (MCP3424 ADC) on arduino like micro-controllers works perfectly on an Arduino Uno R3 and a Teensy 3.2, but...
When I run > sudo i2cdetect -y 1 I see a device driver loaded at 0x6f. I would like to add a device that uses that address. Can I remove the...
I'm having trouble reading a device on the I2C2 bus from the M4. I disabled the BRICKS connector using the Device Tree Editor and rebooted. I...
Separate names with a comma.