DDR calibration using NXP tool

Discussion in 'UDOO DUAL' started by vudoo, Jun 29, 2018.

  1. vudoo

    vudoo New Member

    Joined:
    Jun 14, 2017
    Messages:
    17
    Likes Received:
    1
    Is there any way that I can use the imx6 calibration tool?
    By connecting the board I can run the tool but I am getting the following message
    Is there a .inc file that I can use to run the calibration tool?
     
  2. vudoo

    vudoo New Member

    Joined:
    Jun 14, 2017
    Messages:
    17
    Likes Received:
    1
    This forum is more dead than a dead tree. Maybe I would answer this by myself in a few days. Maybe not.
     

Share This Page