Ok so i have started building this generic plexiglass case. I have attached a picture of the case so far. My only problem now is how to actually mount the board on the case. I need to know what hardware/size screws to use. Any help would be appreciated. Thank you
Mission accomplished. I got it complete now. I know its not the prettiest thing youve ever seen but it does the job. Gives a little protection. The only thing I might rework is the top part. I probably should add some holes for better heat dissapation. Thanks
It would be nice if you add an extra layer at the bottom to place the SATA HDD. Top holes are mandatory to use LVDS, Arduino side, SATA etc.
