magazine article about the production of Udoo X86

Discussion in 'UDOO X86' started by waltervl, Jun 6, 2017.

  1. waltervl

    waltervl UDOOer

    Joined:
    Dec 12, 2015
    Messages:
    2,314
    Likes Received:
    580
    In a magazine about SMT (Surface Mount Technology) I saw an article about some production solutions that were chosen by Seco at the manufacturing of the Udoo X86. It gives some nice background information about the challenges a SBC manufacturer has to deal with.
    Here is the link to the introduction, at the end you can go to the whole article. http://smt.iconnect007.com/index.ph...ess-story-for-the-ud00-x86-seco-board/104518/
     
  2. tuxun

    tuxun Member

    Joined:
    Dec 20, 2013
    Messages:
    67
    Likes Received:
    12
  3. SteveD

    SteveD Member

    Joined:
    May 5, 2017
    Messages:
    36
    Likes Received:
    4
    Thanks for posting, interesting read. I'd be curious to know if this method is going to be applied to all products (udoo) going forward. I would be concerned about the pcb not getting a wash as part of the process, but considering what it'll look like after a year or two anyways with where I'm putting it...well this is a good example[​IMG]
     
    waltervl likes this.
  4. FirstGenGeek

    FirstGenGeek Member

    Joined:
    May 25, 2016
    Messages:
    66
    Likes Received:
    26
    Last edited: Jun 7, 2017
    tuxun likes this.
  5. tuxun

    tuxun Member

    Joined:
    Dec 20, 2013
    Messages:
    67
    Likes Received:
    12
    It works better, thanks :)
     

Share This Page