Going by the manual (rather than my experiences) pins 1 and 4 of the LED to pin 2 of the front panel connector and pins 2 and 3 of the led to pin...
Yes, certain I was using the correct pins, perhaps there's a fault with the pull-up resistors on my board? I'll have more chance to look at it at...
Actually (due to working with Ettore on the HDMI-CEC driver) I have a pre-release 1.04 firmware, but I was running 1.03 when first fitting the LED ...
IIRC the onboard orange/green LED is driven separately from the front panel LED, is there a BIOS setting that can affect this? I purchased a 2pin...
I found that using a 2pin "inverse parallel" LED did not work as per the description in the manual, and I had to fit a 3pin "common cathode" LED...
Finally I have a build ready, but first ... *>*>*> SOME WARNINGS *<*<*< You probably shouldn't upgrade your daily-driver Kodi, at this stage...
I tried a reboot before uploading my image, and it seems I don't remember the correct sequence of cec-ctl/lircd/whatever commands I used last time...
As I mentioned on the other CEC thread, I have built a test libreelec image with CEC support, at first I thought it was only the linux side of CEC...
Just a quick message to say I'm trying to get HDMI/CEC working with libreELEC/Kodi on the UDOO x86, so far I've got the kernel module built and...
Separate names with a comma.
