You might be able to use the Arduino side of the Udoo to act as a traditional parallel port or any other microcontroller programmed to emulate an...
I can only answer a couple of your questions. 1. You only need the signal(s) through the SN74HCT245N itself, however the chip requires powering...
My antenna and screws arrived about two weeks ago.
The screen not showing after a suspend state maybe your monitor or TV not sending or receiving the correct signal to wake up. With my system...
I used M3 (3mm diameter screws)
I don't see the component designator there, but they are probably used as a filter to carry noise in that part of the circuit to ground. So long...
Try disconnecting the HDMI cable from the Udoo and then reconnecting and see if your system now comes out of suspend when you press the on button.
To the OP, try disconnecting the HDMI cable, I have found depending on the TV or monitor used the Udoo will not come out of power save if the...
I bought my fans from Mouser and Digikey, I don't have the part numbers to hand. The downside is that you have to pin your own connectors.
Are you using a wired keyboard or wireless? On very first power up, it seems to need a wired keyboard to get into the BIOS reliably.
If you have the eMMC installed it might be worth checking that grub didn't get installed there and you just need to select the eMMc as the boot...
Tim, Once you are in Windows, open up Windows Disk Management and have a look at what hidden partitions the Windows installer has laid down. It...
Karsten, You didn't mention whether that invoice is from the Kickstarter pledge or from the Udoo shop.
Being a bit of a fan of OS2, I've just purchased the latest clone incarnation from Arcanoae which they are calling ArcaOS. As ArcaOS 5.0 can be...
Separate names with a comma.
