Recent Content by brunod

  1. brunod
    Post

    arduino ide sources please

    Thanks. (I am sure bossa is on its way, right? ;-)
    Post by: brunod, Nov 15, 2013 in forum: General Discussion
  2. brunod
    Thread

    Kernel sources and explaination/documentation

    Hello Team Udoo, In the download page there are links to kernel (and u-boot) source code, but very few explainations, around them. Could you...
    Thread by: brunod, Nov 13, 2013, 1 replies, in forum: General Discussion
  3. brunod
    Post

    Kernel hacking - getting a "clean" 3.0.35 image

    Hi, I tried to get the imx6 pwm to work on my board (pwm1). I made some nice code to fill all the required registers but no way to be able to...
    Post by: brunod, Nov 13, 2013 in forum: Kernels
  4. brunod
    Post

    Using other distros?

    Hi, Following instructions at http://www.elinux.org/UDOO_Installing_D ... ebootstrap (you need to know your way around debian a little bit). I...
    Post by: brunod, Nov 7, 2013 in forum: General Discussion
  5. brunod
    Post

    arduino ide sources please

    Hello, I checked them. They do not work, that what I was trying to say. I get: arm-none-eabi-g++ file not found. When I try to verify the...
    Post by: brunod, Nov 7, 2013 in forum: General Discussion
  6. brunod
    Thread

    arduino ide sources please

    Hello, I am running my udoo on a debian armhf (I followed the instructions at http://www.elinux.org/UDOO_Installing_D ... ebootstrap they worked...
    Thread by: brunod, Nov 6, 2013, 12 replies, in forum: General Discussion