Yeah, I tried a straight through Ethernet cable originally and thought it was odd that it didn't work (haven't seen an Ethernet device that didn't...
No, it's not a software issue (at least not a simple one.) I have assigned static IPs to the Neo's and plugged them into a switch and they work...
Are you using a terminal program to access the Udoo from Windows? IE HyperTerminal or the like? If so you could go old-school and use...
Hi Everyone, I have a strange one here. I have two Udoo Neo's connected with a crossover Ethernet cable and I'm getting no carrier on eth0....
Hmm, for some reason I didn't get an E-Mail update for the responses. Thanks folks, I'll try the OTG adaptor first as that seems simpler than...
Hello, I'm trying to use the OTG USB port that is next to the Ethernet connector as a USB host device, so that I can plug a USB stick into it...
Hmm, can you check your /gpio directory (if you are using the base UdooBuntu image) to see if you have GPIO entries for pins 34 and 35? On my...
Hi Everyone, I've got an NTAG 2C Demo Kit (...
Yup, I tried that but still no luck. I'm not sure if the problem is with the shield we've built or the pins on J6, so we're going to try using...
It doesn't look like it worked, although I was able to break the I2C-4 bus so I'm obviously swinging the sledgehammer in the right area. :)
Hi Andrea, Yup, I've read both of them. The problem is the pinmuxing docs only cover the outer pins. I need to enable 2 of the inner pins (14...
Hey Walter, Thanks, I tried disabling the M4 but that didn't seem to help. I agree that is probably a pinmuxing issue, I'm just not sure where...
Separate names with a comma.
