which are the electromechanical relays suitable for controlling the fluorescent lamp with electronic ballast???
Thank You @Laura
Please guide me..What will be the form factor (Physical area occupancy) if i am using 48
Yes! only few relays will be ON at once (Rarely all) . What is the difference between Latching and non latching relay which one will...
what if i am powering up 48 relays each with supply voltage of 12v dc and 160mA current.
then what should be the power supply rating?
i need a power supply to drive relay coil (12V DC).
i am planning for dual output power supply with 5V and 12V dc output so that i...
ok.. thank you for all your valuable inputs!
ya for that..what if i use TPL7407L as a relay driver?
solid state relays do have some limitations. so i am searching for electromagnetic relay..what if i make use of the following relay...
i would like to control electrical appliances like fluorescent lamps (inductive load).
Anyone please suggest me which relay should i use?...
Thank u for the quick reply..
I need to drive 48 relays..what if i use IC TPL7407L which draws very less current, the data sheet says input...
What is the maximum current we can draw from GPIO pins?
(Current driving capacity of the each pin?)
any help in this regard will be...
Separate names with a comma.