Well scratch that. Only PCI-e gen 1 seems to be stable.
Ok. I started testing again and I think the problem has to do with pci-e gen version. When testing with other PCI-e cards, and if I configure the...
Ok, I just did a firmware upgrade and that didn't change anything related to my problem...
I have a JMicron JMB585 M.2 Sata controller connected over PCI-e to my UDOO x86 Advanced (kickstarter edition). I have a problem where the...
Hi, nice that you found my post. I will make some changes to my NAS. I recently bought a 3d printer, so I was thinking about printing a chassi...
I've been using my UDOO x86 as a NAS since I build it around august 2017 and it's been working very well. I've been using it with zfs and 3 3TB...
I want to add that you can install an ssd through SATA if there is any interest in that, and still use the m.2 key-b slot for dual ethernet.
I've just finished my Udoo x86 NAS, and decided to share my build here. Im connecting up to 5 sata drives (currently using 3) by connecting a...
I'm using UDOO x86 as a NAS with 1 drive currently and Plex Media Server. I'm going to expand to 3 drives on raid5 when I get all the hardware i...
I have successfully splitted my cable and am now using my 3.5 inch hdd. An additional capacitor is located between 12V and ground, rated at 220μF...
I might have to purchase a new power supply then. Was looking at 60W ~ 5A which should be enough. I actually have the same drive! Not sure if 3A...
Ok, I think I'm going to split the power from the power supply directly and use the 4-pin molex connector. Adafruit is no solution for me though,...
Ok, thanks for the quick reply! Any suggestions for solutions to power my hdd? :)
Hi, I'm trying to get my 3.5 inch hdd to work with my UDOO x86 with the added starting kit, which includes a harddrive power cable. Am I doing...
Separate names with a comma.
