That being said, there's some known issues with the Intel Curie when it comes to I2C support. Just because it works on a real Arduino doesn't mean...
I would definitely NOT recommend it... Or at least, don't expect good things to happen if you try.
PLA should be fine. It doesn't really start melting until around 160C, and if your Udoo is putting off that much (and air flow isn't moving it...
Don't feel bad... I did the same thing when I received my 1080 graphics card. Day I got it I went to remove the stock cooler so I could set it up...
Markus: I think he's agreeing with you here... ;) Seeing people buy these things to use as NAS or Media centers and doing all the whacky mods to...
For 3.5" SATA hard drives... 2.5" laptop style SATA drives usually will work fine with just 5V.
Already completed! UDoo x86 #1 in my book :)
Anyhow, just to further my point about preferring the Udoo - Where I work (Robotics research group for a Fortune 500 company) was looking for...
Ok, so somebody who has Windows installed give CPU-Z a try and see what it reports. I only have Ubuntu 16.04.2 installed...
Well, to be fair, while it has an onboard FPGA, it is yet to be seen whether they're going to provide us a way to modify the code on it......
Well, I didn't post it to make UDoo look bad. Quite the opposite, I see each board as being very good and just different. I prefer the layout of...
OF COURSE newer hardware is less likely to have all the drivers available. The point is, that's NOT the case currently from what I've seen. The...
Ok, I still don't get what the heck your point is? Why is that a problem? What is the effect of what you're saying? What the heck diff does it...
Ok, something is definitely up then... I just got my Up2 board which uses a 1 generation newer CPU, 1.1Ghz base, with 2.5Ghz burst mode. cat...
Ok, I have ABSOLUTELY no idea what you were trying to point out there... I was running Ubuntu 16.04.2 on both boards... I wasn't trying to...
Separate names with a comma.
