Yes they did. Sent from my iPhone using Tapatalk
I ended up creating a ticket. Then had me go through a few more step to debug this issue and they concluded that my chip was burnt. I would...
Correct, it was working before. And it still works. But the way to make it work is not normal. It doesn't work with RC1 at all. But i managed to...
The wifi icon on the status bar where list of wifi is displayed shows Wi-fi is disabled. Any idea?
The wifi list in the quick configuration section is empty. Cannot select any wifi.
iwconfig return wlan0 no wireless extensions. lo no wireless extensions. eth0 no wireless extensions. usb0 no wireless...
Hi all, My neo stopped connecting to my local wifi today. I tried flashing a completely fresh udoobuntu, and the area where it usually shows the...
How do you know that the value is always 0? Do you have an LED connected? does the LED turn on and off? Did you try to read the value by if you...
I would be interested in seeing this as well. Please upload if possible.
I am interested in doing this as well. I hadn't thought about it but I am sure i will run into same problem in future.
The table you are looking at is for udoo, not udoo neo, please look at this for the correct GPIO numbers....
I followed the steps you mentioned, but i still cannot run run export without sudo.
If you read the document it says; If you put an LED on that pin out, you can actually see that the led will turn on.
The function seems to be working properly. It looks like you export whatever GPIO_xxxx you see in the diagram. So what is the point of the formula?
Separate names with a comma.
