Recent Content by nhenault

  1. nhenault
    Post

    GPIO Output Pins Not Changing State

    Yes, I have been using sudo -i before running all of these commands because only super user can actually alter the files.
    Post by: nhenault, Aug 11, 2018 in forum: UDOO X86
  2. nhenault
    Post

    GPIO Output Pins Not Changing State

    When I initially booted up the computer I got this: ~$ ls /sys/class/gpio export gpiochip228 gpiochip341 unexport gpiochip225 gpiochip314...
    Post by: nhenault, Aug 10, 2018 in forum: UDOO X86
  3. nhenault
    Post

    GPIO Output Pins Not Changing State

    Here is some more information if it helps: 1. I tried the Braswell GPIO pins on CN12, specifically physical pins 43-46 which are pins 329, 330,...
    Post by: nhenault, Aug 10, 2018 in forum: UDOO X86
  4. nhenault
    Post

    GPIO Output Pins Not Changing State

    I know, this was throwing me off as well, but I am getting the same 3.3V reading on multiple separate UDOO x86 Ultra boards. They are also new so...
    Post by: nhenault, Aug 10, 2018 in forum: UDOO X86
  5. nhenault
    Thread

    GPIO Output Pins Not Changing State

    Hello, I have encountered this issue on two separate and new UDOO x86 Ultras so I don't believe it is from board damage. When I set GPIO pins, for...
    Thread by: nhenault, Aug 9, 2018, 13 replies, in forum: UDOO X86
  6. nhenault
    Thread

    UDOO x86 - Can't Set Certain Arduino I/O Pins High

    Hello, I have recently noticed that I am unable to set a HIGH voltage on GPIO pins 8-15 on the Arduino on my UDOO x86 Ultra. The code I am running...
    Thread by: nhenault, Jun 12, 2018, 0 replies, in forum: General Discussion