Recent Content by sam7281

  1. sam7281
    Post

    I.MX6 UDOO CAN BUS

    I tried, it can not receive any signal There may be driven by its own did not write, resulting in this did not work?
    Post by: sam7281, Jan 11, 2017 in forum: UDOO QUAD
  2. sam7281
    Post

    I.MX6 UDOO CAN BUS

    I replaced SN65HVD230, Udoo also replaced by a new one. But I send command "cansend can0 500#1E.00.10" Will become BUS OFF Why? Has anyone...
    Post by: sam7281, Jan 5, 2017 in forum: UDOO QUAD
  3. sam7281
    Post

    I.MX6 UDOO CAN BUS

    I tried .same result Is it really easy to use a CAN bus? What direction can go to check it?
    Post by: sam7281, Dec 29, 2016 in forum: UDOO QUAD
  4. sam7281
    Post

    I.MX6 UDOO CAN BUS

    Yes,I use (USB to CAN BUS device) test,but UDOO CAN BUS still no work I asked UDOO customer service, they said that as long as the use of...
    Post by: sam7281, Dec 29, 2016 in forum: UDOO QUAD
  5. sam7281
    Post

    I.MX6 UDOO CAN BUS

    625K is correct, CAN tx / rx is also correct to receive TJA1050 tx / rx In its CAN devices to TJA1050 tx / rx is OK. Do you have normal CAN BUS...
    Post by: sam7281, Dec 29, 2016 in forum: UDOO QUAD
  6. sam7281
    Profile Post

    Hi I'am http://www.udoo.org/forum/threads/i-mx6-udoo-can-bus.6394/ thanks for your reply. I...

    Hi I'am http://www.udoo.org/forum/threads/i-mx6-udoo-can-bus.6394/ thanks for your reply. I don't know why can bus can't work I need your help....
    Profile Post by sam7281 for jas-mx, Dec 27, 2016
  7. sam7281
    Post

    I.MX6 UDOO CAN BUS

    Thank you for your reply Yes I change 0x1b0b1 ,I check flexcan1 status is okay(work)&my transceiver is TJA1050 But When I.mx6q can rx tx link ,It...
    Post by: sam7281, Dec 26, 2016 in forum: UDOO QUAD
  8. sam7281
    Thread

    I.MX6 UDOO CAN BUS

    How can i open I.MX6 UDOO CANbus? I test this code pinctrl_flexcan1: flexcan1grp { fsl,pins = < MX6QDL_PAD_GPIO_7__FLEXCAN1_TX 0x80000000...
    Thread by: sam7281, Dec 25, 2016, 13 replies, in forum: UDOO QUAD