Check the current rating on those. Generally they are listed with a max of 1A or so, but people report them getting extremely hot and failing at...
Depending on your case and power consumption, you can probably grab the 12v from the existing power supply. I split the incoming power cable and...
As you stated the supplied power supply is 3A. I have my board (Advanced) running with nothing attached and I think its closer to 1.5A under load.
The original thread discussing this --> https://www.udoo.org/forum/threads/ultra-in-what-situation-should-it-boost-up-to-2-56ghz.6989/ I have the...
My Advanced running Debian Stretch idles around 37-40c. Using stock heat sink with no fan or air flow. Located in my basement with 18-20c ambient.
I'm using ffmpeg as well with h264_vaapi Input video is OTA Video: mpeg2video (Main) ([2][0][0][0] / 0x0002), yuv420p(tv, top first), 1920x1080...
Udoo X86 Advanced (Debian Stretch) sysbench 0.4.12: multi-threaded system evaluation benchmark Running the test with following options: Number...
I'm using LIRC with a cheap IR receiver going to a GPIO pin on a Raspberry Pi. I haven't looked into the GPIO pins on the X86 but might be a...
https://www.udoo.org/forum/threads/bracket-for-80mm-ssds-available.6856/
The connector is the same so you can use any length board. It will just stick out past the side of the board and you have to support it somehow....
Have been running stretch on my advanced for the past week or so. No issues so far.
Have been running stretch on mine for the past week without issue
Ok, was a long shot but wanted to confirm.
Just to confirm your data point. I pre-ordered an Advanced Plus on Jan 23, 2017 and received my board last week (United States)
No other graphics or peripheral connected? From Microsoft:
Separate names with a comma.
