Recent Content by spinxz

  1. spinxz
    Post

    Keep arduino 101 running while braswell or OS is off

    I agree that it should be in the bios. As mentioned it could be related to the Curie Reset on PowerON bios setting which is needed because of the...
    Post by: spinxz, Apr 24, 2017 in forum: UDOO X86
  2. spinxz
    Thread

    Keep arduino 101 running while braswell or OS is off

    Hi When I load the Arduino Blink example onto the 101 it works fine until I shutdown the operating system. Turning off the OS/Braswell also stops...
    Thread by: spinxz, Apr 23, 2017, 6 replies, in forum: UDOO X86
  3. spinxz
    Thread

    UDOO X86 power consumption

    Hi I did some measurements to determine the power consumption of the UDOO x86. You might find the results useful. Setup System: Udoo x86...
    Thread by: spinxz, Apr 23, 2017, 1 replies, in forum: UDOO X86
  4. spinxz
    Post

    Pinout Labels for Headers

    Thanks a lot!
    Post by: spinxz, Jun 11, 2015 in forum: General Discussion
  5. spinxz
    Post

    Pinout Labels for Headers

    Download from forum does not work again... Thanks for the great labels!
    Post by: spinxz, Jun 11, 2015 in forum: General Discussion
  6. spinxz
    Thread

    minimize sleep power consumption for solar powered system

    Hi, I am trying to build a sensor/meteorological station with the Udoo. However, the system will have to run "in the wild" on a battery which is...
    Thread by: spinxz, May 4, 2015, 2 replies, in forum: General Discussion