No i don't found my solution, i have the last release 2.0.2 and no found since ...
TU waltervl, I take a look in that link (but for me, lock up requiring a reset, appeared before access IMU)
I use standard library not added others.
Hi all, My Udoo freezes after a few minutes of good operation. Is there an arduino supervision software? or supervision software via Braswell? I...
For sure :-)
In conclusion, it is necessary to read USB port side Braswell before genuino soft side start ...
I don't understand, when i add CurieSoftwareSerial, only SoftwareSerial.h file is added !!! It's the same library that SoftwareSerial choosed !!!...
Idem, virtual uart stop working at 20' :(:(:(
I tried with less speed on virtual uart (pin 9 & 10) , i send a string with 32 characters all 100ms. At 19200Bds, worked ok during 23' Now i...
Another test without CurieSoftwareSerial lib but replaced by uart build in one work fine.
The one i created with CurieSoftwareSerial. But for this test, i didn't use interrupt, only this virtual uart in Rx ....
Yes I use that library, but after any minutes, uart stop to work without know why ???
Not possible for me, I used UDOO ULTRA board with genuino 101 embedded .... I tried too NeoSWSerial lib but it doesn't work with my MCU !!!...
I tried to use SoftwareSerial.h librairy but il doesn't work in my case, because i have a lot of gpio interrupts and full duplex on uart...
Separate names with a comma.