Excellent. I will give it a go today. Thank you, Ed
OK, it will boot right into the OS no matter what. ESC held down or rapid pressing. Nothing with SATA disk disconnected, not even a boot error. I...
Edit: I have also tried unplugging SATA hard drive & no USB thumbdrives, or any other bootable device.
I cannot enter BIOS at all. Tried different monitors, all 3 video ports & 3 different keyboards (Plugged directly into Udoo, no hub). I have tried...
Well, my X86 Ultra is going to be a mobile Software Defined ham Radio: X86 Ultra LimeSDR-USB BPFs/LPFs/PA/TX-RX board from a Yaseu FT-857D (All...
I do not really see the need for such a large cooling fan. Also, it may fatigue the board, without extra support. Just observations. Ed
Hello, it's been a bit since I loaded the OS. I do not know why it went in as "Legacy", but I would like to change that to EFI. I will also be...
I thought that there were 2 lanes. I'll have to look again. If you have it working, could you post comparitive rspeed results, compared to another...
I have all of the Harwin numbers at work. Also, instead of a $300-$700 crimp tool, you can get preterminated wires to put in the socket. Ed
Worst case scenario, I could cut several off with 6" pigtails & you can use them that way. If I dig deep enough into the scrap wire bin at work, I...
Email me at KG7SWP@yahoo.com & I will get you all the part numbers on Monday. I pulled mine from small LCD driver units we use at work. I have the...
An Ad-Hoc WIFI connection should do. Ed
It will pose no problem. But, you must use spacers to raise the height, to fit the NGFF units & battery. In my first post to you, I was a bit...
What I am trying to tell you, is that using internally threaded standoffs(Spacers), you move the board up .375". The metal standoffs, screws, nuts...
Separate names with a comma.
