I have two UDOOx86s. One from kickstarter and another purchased recently. Found that new one is not detecting sdcards in Debian9 even with...
If you are fine with connecting 3.5" to usb3, This usb3-sata can be used(cheapest I know). It has 5.0mm/ 2.1mm 12V dc hole for power. Also, it has...
I got this printed for 100Rs(1.5$) from 3deometry( http://3deometry.com/ ) at Pune, India. I had to use screw driver to widen holes to fit screws...
bump
Hello Laura, I recently ordered udoox86 in Indian and paid 83$ custom duty. I want to create thread about it. Not sure which section I should...
My advanced plus(all four cores) settled on 1759.960MHz for 15+ minutes when I did kernel compilation using '-j 6'. Temperature for all cores were...
Solved this by moving from bios mode to efi. Now I can boot from Debian on /dev/sda5 without any problem. Though it should have been bootable in...
I did quick installation of debian in another partition of 3TB sata and it is booting fine. This partition is at the beginning of hdd. I checked...
Installed debian to eMMC in legacy mode. It is booting fine. But I want to boot debian on my sata hdd. When I attached sata, Grub2 on eMMC...
I have been able to successfully read and write all data on my 3TB sata hdd on UdooX86. This hdd gets listed under legacy devices in BIOS. But I...
I had sata power cable came with asrock 3160dc-itx. That fit perfectly in UdooX86. Disconnected 12V wires and attached to 12V 1.5A adapter and it...
Separate names with a comma.
