mode hibernation/sleep

Hello,

I am having an issue with my udoo x86.
I was uploading a sketch to the arduino 101 and I accidently switch off the power.
When I powered it on again the led became orange.
I verifyied the voltage I have 5V_ALW and 3.3V_ALW.
However I don't have the 5V_C and 3.3V_C which seem to be due to cause the inexisting signal curie_power_en.
I tried everything like power it off and de energizing then power it on and press the two buttons to wake the card. I removed everything connected to the card and powered it on.
When the led is orange it draws 0,11 A.
I don't know what to do to wake up it from this sleep mode.
I don't have any video output.
And all my work is on the udoo I can't get access to it.

Thanks for you help

 

If you press ESC, ESC etc during boot you should be entering the UEFI menus where you can set boot options.

 

I tried pressing ESC but nothing happenned and I still have no video output on the screen

 

It is a drastic measure but you can reset the UEFI settings by removing the RTC battery. https://www.udoo.org/docs-x86/Hardware_Reference/UEFI_Firmware.html

 

I already did it, I unplugged the RTC battery, the power and all the devices.
I let the board rest during one night and tried the other day but still the led is orange.
If I can't wake up it from this sleep mode Can I at least get access to the files stored on the board somehow?

If I connect the udoo x86 to my pc through usb, will I detect it and will be able to get access to the files stored on the emmc ?

 

I do not think so, you better open a ticket at customer care for more technical assistance. https://www.udoo.org/customer-care/