Does the UDOO Camera module work with the X86?

Discussion in 'UDOO X86' started by lamoid, May 3, 2017.

  1. lamoid

    lamoid New Member

    Joined:
    Feb 20, 2014
    Messages:
    4
    Likes Received:
    1
    I bought a UDOO camera module for my UDOO Quad. Can the same camera be used with the X86? The page that describes the camera module says:

    UDOO Camera module is designed to be connected via CSI interface to UDOO Camera Connector. Connection is made via a FLAT-213-16PIN cable.

    I see no CSI interface mentioned in the X86 documentation, so I presume it does not have one. Any suggestions for using the camera with the x86?
     
  2. ccs_hello

    ccs_hello UDOOer

    Joined:
    Apr 15, 2017
    Messages:
    536
    Likes Received:
    194
    There is no camera CSI interface on UDOO x86 board.
     
  3. Wilson

    Wilson New Member

    Joined:
    May 5, 2017
    Messages:
    25
    Likes Received:
    9
    This is very concerning to me. Not only is connector CN27 shown populated on the back of the board in photos on the kickstarter page and webstore, but the MIPI CSI interface is definitely shown on sheet 22 of the schematic. Are connector CN27 and the relevant ICs not populated on the boards people are receiving now? Is there a reason for the disconnect between the documentation and reality?
     
  4. ccs_hello

    ccs_hello UDOOer

    Joined:
    Apr 15, 2017
    Messages:
    536
    Likes Received:
    194
    Schematic diagram remark stated CFG = DNP
    which means the configuration is "Do Not Populate".

    Entire camera interface related circuitry is not populated.

    ccs_hello
     
  5. Wilson

    Wilson New Member

    Joined:
    May 5, 2017
    Messages:
    25
    Likes Received:
    9
    I missed that note when I looked at it. Thanks! Still disappointing. :(
     
  6. MarcLaos

    MarcLaos New Member

    Joined:
    Jun 14, 2017
    Messages:
    3
    Likes Received:
    0
    I just played with a USB 3 industrial camera from Ximea. It was working without any problem
     
  7. winsonlcc

    winsonlcc New Member

    Joined:
    Oct 30, 2014
    Messages:
    8
    Likes Received:
    0
    Hi MarcLaos,

    Can I have the exact model you bought from Ximea? What OS are you running on your Uddo board?
    I wish to buy a camera use for Udoo x86 board.
    Thanks
     

Share This Page