Device probe failed for CEC

Discussion in 'UDOO X86' started by trs, Feb 7, 2020.

  1. trs

    trs UDOOer

    Joined:
    Mar 10, 2018
    Messages:
    3
    Likes Received:
    1
    I have succesfully compiled the seco-cec.ko kernel module and am using bios 1.06. On boot, I see the following in dmesg:

    There isn't any CEC device created. All the GPIO settings in the bios seem to be enabled. Is there anything else I could try? Thanks.
     
  2. trs

    trs UDOOer

    Joined:
    Mar 10, 2018
    Messages:
    3
    Likes Received:
    1
    It turns out I had to load the pinctrl-cherryview kernel module first, then the seco driver loaded correctly.
     
    waltervl likes this.
  3. Tal Ball

    Tal Ball UDOOer

    Joined:
    Dec 18, 2021
    Messages:
    1
    Likes Received:
    0
    Hi @trs, Does this mean that you got the IR interface working? Is it possible to share instructions? Thanks.
     
  4. CharlesS

    CharlesS UDOOer

    Joined:
    Nov 7, 2022
    Messages:
    6
    Likes Received:
    0
    Thanks for the information, I will try to figure it out for more. Keep sharing such informative post keep suggesting such post.

    My Lowes Life
     

Share This Page