Arduino keep working

Discussion in 'UDOO BOLT' started by Fatih, May 11, 2022.

  1. Fatih

    Fatih UDOOer

    Joined:
    May 11, 2022
    Messages:
    1
    Likes Received:
    0
    Hello, When we turn off the system, the arduino and fan of Udoo Bolta continue to work. I'm curious about your suggestions for shutting down the Arduino. Thanks.
     
  2. NickGR

    NickGR UDOOer

    Joined:
    Jun 23, 2020
    Messages:
    105
    Likes Received:
    20
    The attached Arduino is working correctly, it should remain operational as a seperate board no matter the state of the rest of the Bolt.
    I even trying to use the Wake# (EC Pin 12) to wake up the Bolt from the Arduino with sensor events, that would not be possible if the Arduino was being shutdown as well.

    I am not sure why your fan is working after you shutdown the main board though.
     
  3. NickGR

    NickGR UDOOer

    Joined:
    Jun 23, 2020
    Messages:
    105
    Likes Received:
    20
    Correction, Wake# is Pin6
     

Share This Page