No device found on ttymxc3

Discussion in 'General Discussion' started by Tannyveer, May 30, 2014.

  1. Tannyveer

    Tannyveer New Member

    Joined:
    Feb 19, 2014
    Messages:
    33
    Likes Received:
    0
    Hello Sir
    I run udoo arduino serial port program reading analog pin. After that i can modify the program again i can run the program. Right now the program cannot upload it shows the error no device found on ttymxc3 . May be SAM3x controller damaged is there any solution for this one please suggest me. awaiting your replay.
     
  2. asvaldr

    asvaldr New Member

    Joined:
    Oct 18, 2013
    Messages:
    24
    Likes Received:
    0
    I've just had the same happen to me.

    Mine has been working for many months. I decided to leave it going as a database server running the meteo tutorial. To know all was good, I used an interrupt to toggle an LED (all on 3.3v with resitistor); anyway a week later i notice its not running anymore.
    I try to reprogram and i get the same error.

    So it just dies all of a sudden?
     
  3. Tannyveer

    Tannyveer New Member

    Joined:
    Feb 19, 2014
    Messages:
    33
    Likes Received:
    0
    Hi
    I replaced the SAM3x IC with same IC now my udoo quad is working fine now.
     
  4. asvaldr

    asvaldr New Member

    Joined:
    Oct 18, 2013
    Messages:
    24
    Likes Received:
    0
    Wow. How did you do that. Have you got special equipment?
     
  5. delba

    delba Administrator Staff Member

    Joined:
    May 8, 2013
    Messages:
    1,064
    Likes Received:
    9
    Awesome Tannyveer
     

Share This Page