Hi Jürgen, even that your message is a bit older, I like to share the link with you. We created an universal bundler to setup meterojs on UDOO....
Hi, I have posted a nearly similar discussion here: how-setup-gpio-state-sam3x-when-kernel-not-booted-t1851.html I wanted to have the subject...
Hi, our problem may be a bit similar like gpio-default-state-t811.html but I decided to add this as a seperate title. Problem is: We are using...
Hmm ... I cannot confirm this. As on my tests with python on Ubuntu 14.04 core everything worked. I am not sure per 100% but I wil send a short...
Hi Peter, I am happy for you that at the end of this pain there was a solution. Thanks for sharing your knowledge.
Re: getting i2c_1 working Hi Peter, maybe you should completly drop the src files and start with fresh load from GitHub. Also, if possible,...
Hi, just to give some positive response. I got by now 4 DUALs and 2 QUADs and ordered two connection packages as well. The plugs in my pack all...
Re: getting i2c_1 working J21 PIN 9/10 - SCL1/SDA1 - SAM3X only => Wire1.begin() J5 PIN 1/2 - SCL/SDA - SAM3X => Wire.begin(); ####### iMX6 -...
Re: getting i2c_1 working Hi Peter, I case of the cabling stuff, I looked once more for the CAM Adapter. For that you can find wires named...
Re: getting i2c_1 working Great, so you also had been able to use the i2c bus from iMX6 side. I really wonder why they have not linked the pins...
Re: getting i2c_1 working Btw. this is the right connector. I still have not found a ready manufactured cable yet...
Re: getting i2c_1 working Hi, I prepared myself two small connectors (clips) using a heat shrink tube. and put this on Pins 12 and 19 in...
Re: getting i2c_1 working Hi, I also will proceed with plug for CN13. Have not found the right plug by now. I will check at a local distributor...
Re: getting i2c_1 working Comment to Arduino Wire Library: Wire.begin() referres to Pins SCL1 and SDA1 on Jumper Block J21 Wire1.begin()...
Re: getting i2c_1 working Hi Peter, I have not tried to compile the right now but I used the I2C3 on Pins 12 and 19 on Connector CN13. When I...
Re: getting i2c_1 working Next look in diagram shows up, that COL3 and ROW3 is located in the HDMI connector. Maybe it is neccessary for HDMI as...
Re: getting i2c_1 working I guess you are still at the same point as me ... I2C is not yet working on the iMX6 side. Just to repeat / clarify...
Have you been able to use I2C with a python script from Linux side? If yes, could you be so please and publish your demo command. I have tried a...
Re: getting i2c_1 working Hi, if I do understand the documentation, you have to "comment out" the GPIO macros // MX6Q_PAD_EIM_D21__GPIO_MODE,...
Separate names with a comma.
