On fresh reboot without plugging in joystick I got this udooer@udooneo:/dev/input$ tree . |-- by-path | `-- platform-20cc000.snvs-pwrkey-event...
I did not mentioned in my initial port that I did install joystick. But thenk you for trying to help out. But also I do not see jsX in /dev/input/...
I have problem with udoo neo board detecting USB joysticks. I am using simple SDL2 test app that I have build and running minimal image UDOObuntu...
Did anyone figured out how to enable it on boot? Adding below entry to /etc/networking/interfaces does not do usual trick # CAN Bus auto can0...
cyrilf Do you have clean downloadable image I could try. I am interested in QML or Neo board with EGL. Before I spend time on figuring out how to...
Hello, I am researching QML/QtQuick 2 on Udoo Noe Full. I am interested only in developing full screen apps. As of not I have UDOObuntu 2.1.1...
404 Page not Found :)
Ok I was able to setup and install Indigo on Full Neo with UDOObuntu 2.1 Minimal (14.04 LTS) Release Date: 2016-09-28 If you need WIFI working...
I did not have chance to setting up ROS on it yet. Working ons cross compiling toolchain on Mac to do ARM development. I am hoping this weekend or...
I was able to rebuild minimal from source and I got WIFI working!!! EDIT: Actually I did go back to udoo neo minimal released version and I got...
So I found on your side http://www.udoo.org/other-resources/ section to get and build kernel. One obvious part is that clicking on "How To Compile...
Would this work with Neo? I am looking for image (ubuntu preferred) that I could later install ROS.org on it.
I was was wondering if anyone here is using ROS on Neo board. I did try to use udon neo minimal image (looks great) but as of now WIFI is not...
For WPA2 only networks I got this working. Also you can edit ctrl_interface=/var/run/wpa_supplicant ctrl_interface_group=0 update_config=1...
Ok... So image was build on Ubuntu 16.04 LTS and it did booted from SD card just fine. So Thank You Very Much for your help and support!!!!...
Thank you. Just started the build. Will let you know in a few UPDATE: I was able to build with out any errors. Will give it a spin in a few.
S Sure thing. Let me know when you get to it and I will give it a try again. Thank you for all your help!!!!
Ok so I did clean pull and build. I got same issue as I reported. So then I did try bitbake -c cleanall udoo-image-full-cmdline bitbake...
Ok So I started fresh build just some time ago and I got this error message after some time building. I am building on 1604LTS server with latest...
Just to let you know I was trying to build this on new freshly installed 16.04 server and at some point I got error that python was not installed....
Separate names with a comma.
