Yes you can set up different args to make it boot from different drive etc and make it boot my typing the command , run sata1 . but on the...
The normal ways are connect via SSH , Connect to the Serial USB serial port and log in like you would with SSH. Check the router , which if it`s...
I may be wrong , but dual boot does not normally mean boot to A or B , but if A is not there ( Fails ) boot to B the backup route. Eg if you...
It should be compatible with any shield which works on the Arduino DUE.
ifconfig
I think the problem is you have change images and still using the same ip address . eg with Putty when you change images you get a the keys have...
I could not find any problems with the Debian Wheezy ARMHF beta1 image, I ran it full time on my udoo until it died , unrelated to any software I...
Re: can Adafruit Webide install on udoo, using node.js & pyt I guess the other method is direct access and change the cpu`s registers direct !!!!...
Re: can Adafruit Webide install on udoo, using node.js & pyt If you look at the Raspberry documentation on how to control the gpio pin using bash...
Re: Why it so slooooooooooooooooooow? I could not see any difference between a standard class 10 and the super 75-80 mbps cards. But I did see a...
Re: Why it so slooooooooooooooooooow? The best way to check for I/O bottlenecks is looking at the wa percentage with top, which is the amount of...
Never used the program but found this :- https://www.youtube.com/watch?v=RGRhIQn ... detailpage
Long story short , I`ve been using my udoo headless most of the time and using the Arduino part ,but yesterday I installed Debian from base up ,...
I think it all depends what you want to share ? If you for example want to share a array / file , use samba , map a directory on one ( share ) ,...
I had problems with errors compiling via the internal linux os , so I use a P.C to compile it now .
Yep , I`ve download the source files and it is still only designed for I386 . I will have to work out to add ARM to the arc list . ( build.xml )
Page 34 of the manual :- External pins are set in input mode, in order to prevent problems with SAM3x8E signals. Not sure you could say that...
If you are using the SAM part only , just program like you would do normally. What they are saying is , DON`T run the blink sketch which uses pin...
NO !!!! pin = ??; pinMode( pin , OUTPUT); and digitalWrite( pin, LOW); or digitalWrite( pin , LOW); The best way is to look at the examples , eg...
I downloaded the Linux. version, but found it was pre compiled for i386. Is there a source version, where I can compile it myself?
Separate names with a comma.
