Now step 2) -- create a 12V power cable for this PCIe adapter. Find a scrap old 3.5" floppy disk power cable. Only use the Yellow and Black...
Use sudo lspci -vv to show that the controller indeed is taking advantage of PCIe x2 (2 lane bus) [ATTACH] ccs_hello
As you see see in the first pic in post 1, there is a 4-pin Molex mini power socket (the one used in 3.5" floppy drive.) It will be needed to...
Step 1) cut a slot (blue shaded one) using Dremel saw wheel. Cut the center line first. then gradually move sideways to create the "B" slot. Make...
I think it is the time to explain the step-by-step on how to convert UDOO x86's NGFF M.2 B-key (a.k.a. NGFF socket 2) to a regular sized PCIe...
I received my regular PCIe x2 SATA card today. I verified it is PCIe x2. (P.S. LnkCAP is capacity declaration; while LnkSta is the actual...
Thanks Jura! Yours must have been operating in PCIe x1 mode as high lighted: ... LnkCap: Port #0, Speed 5GT/s, Width x1, ASPM L0s L1, Exit Latency...
Hi, Can you verify that the board is running at PCIe x1 or PCIe x2 mode? Thanks! ccs_hello
You really don't want to overload UDOO x86's internal 12V -> 5V inverter, since its primary use is to supply power to the board itself, not to...
Buy this one (AC 110V/220V to DC 12V + DC 5V power adapter)...
http://www.udoo.org/forum/threads/bracket-for-80mm-ssds-available.6856/
It is PCIe 2.0, per Intel Braswell N3160 datasheet. ccs_hello
Schematic diagram remark stated CFG = DNP which means the configuration is "Do Not Populate". Entire camera interface related circuitry is not...
There is no camera CSI interface on UDOO x86 board.
Actually it's not that difficult to constantly supply Arduino 101 with constant power (needs both 3v3 and 5V) thru 2 hardware soldering jumpers...
I am currently under BIOS/UEFI firmware version 1.01. Under this version, S3/4/5 will turn off Curie power. This power is controlled by STM32...
http://www.udoo.org/forum/threads/keep-arduino-101-running-while-braswell-or-os-is-off.6864/ Post #6 contradicts yours. Also Arduino 101's IO9...
Buy "USB CAN Adapter" or "USB CAN Analyzer" from Amazon or eBay.
Yes on both (SATA Drive on regular SATA port and mSATA SSD on M.2 socket.) ccs_hello
Make a note to myself... UDOO x86's User Manual page 29 pin 3 HD_LED_N Hard Disk activity LED really should have been clarified as LED for SATA...
Separate names with a comma.
