It may be a stupid question , but does the iMX6 processor have any ADC channels ? I guess that's the first thing to do you get access to them at...
where ? , My udoo dead after 2 weeks which as been my problem with it, because rapid electronics as had my udoo longer than I have . but while I...
Obviously this is one I will never win, because no matter what evidence I will give you it will just be ignored, so this is my last post on this...
Sorry I am being civil !!! First we are going back to what already been established. The schematic set DOES show pull-up resistors !!! No ,...
That`s like going on a volkswagen forum and asking if the oil is easy to change , AND not saying that you have a Ford car. The Arduino Due may not...
Re: Problems connecting via SSH Try backing up /Users/alexandrosdrymonitis/.ssh/known_hosts and deleting what`s inside. That way it should...
I think it is the same problem as tying to get the udoo board to fell asleep ( power saving move ) and use the real time clock to bring it out of...
Plus one on that , my favorite image would be a image with only the most basic packages install, but stable and with good working repository...
Re: -bash: make: command not found This is my quick list :- ( FROM BASE ) apt-get install firmware-ralink wpasupplicant wireless-tools #<---...
Having Uboot stored on the sd card doesn`t alter the boot speed , or stop you from dual booting etc , or change anything , and stop you doing...
The due and the udoo due may be different, if the schematics are true the udoo is fitted 4.7k resistors instead of 1k. I've used both I2C ports on...
The Ubuntu image uses eth6 , but the debian image uses eth0 , so it can`t be uboot setting it. I tried to fix that , but had so many other problem...
I would say it`s possible , but not feasible !!!! Like I said before, you are completely changing the way it is designed to boot . what you are...
THERE IS NO NAND FLASH INSTALLED ON THIS BOARD , IT`S DESIGNED TO USE THE SD CARD TO BOOT. You are asking "why doesn`t my diesel car run on...
I`ve read a benchmarking review about I think the cubieboard , and the reviewer was saying that the performance wasn`t up to a typical P.C of 6...
Sounds like the GPIO pin is biased to high with a pull up resistor . So pick a pin which isn`t used for I2C or switch off the pull up resistor ....
I edited my last post , so I don`t think you saw my added bit. BUT that also look like a DNS problem too. check /etc/resolv.conf which should...
GOOGLE is your friend https://www.google.co.uk/#q=apt-get+or+aptitude+ubuntu
I got that at first :- try : apt-get update ... then .... apt-get upgrade Also check for "apt-get install ntpdate" which sets the clock via the...
My udoo in for repair , so can`t test anything . Never tried Android so don`t know how it boots , but should be about the same . Looking at the...
Separate names with a comma.
