Search Results

Thread

The Udoo Neo doc pages in Power Management have: Power sources You can power up the board in 3 ways DC-jack: internal positive, Voltage 6 to...

Thread by: Gary Huband, Nov 14, 2016, 18 replies, in forum: UDOO NEO

Thread

I want to program the Neo M4 from my Mac (El Capitan) using the Arduino IDE v1.6.9 over the network. So, I followed these directions...

Thread by: Gary Huband, Sep 28, 2016, 6 replies, in forum: UDOO NEO

Thread

The below code to detect I2C devices (MCP3424 ADC) on arduino like micro-controllers works perfectly on an Arduino Uno R3 and a Teensy 3.2, but...

Thread by: Gary Huband, Sep 8, 2016, 4 replies, in forum: UDOO NEO

Thread

When I run > sudo i2cdetect -y 1 I see a device driver loaded at 0x6f. I would like to add a device that uses that address. Can I remove the...

Thread by: Gary Huband, Aug 30, 2016, 5 replies, in forum: UDOO NEO

Thread

I'm having trouble reading a device on the I2C2 bus from the M4. I disabled the BRICKS connector using the Device Tree Editor and rebooted. I...

Thread by: Gary Huband, Aug 17, 2016, 3 replies, in forum: Arduino IDE