I would say that you can put the RFS on a usb stick , but the uboot HAS to be still on the sd card , so you can`t do away with the sd card.
glad to know , and will have to try it and see if it works for me.
The way I do it is leave the kernel still on the sd card and just install the RFS on the sata drive . That way it`s easier to upgrade or change...
I have a crucial mx100 - 512 GB and a Agility 3 oct - 128 GB , which are both 6 gb/s sata drives. They both work on the udoo , but the mx100 has...
If you cut the power the Sam side should go back to default . I`m 99.9% sure this is what happens !!!! 1/ You power cycle !!!! .... REMOVE THE...
I think you may be confused about Pin Muxing . Pin Muxing is a way to turn a gpio pin into a special function like , serial , i2c , spi . Which I...
Have a search for :- "firmata android" and there are some programs which controls a arduino using firmata for android , but to do honest I have no...
If you only use one of the side , sam or imx6 you don`t need to be concerned . What they are saying is don`t set both sides to output !!!!. I`ve...
You say to copied the mmc to sda2 , so you have set satapart=2 .. ?
I have a 80 gb SSD and that boots like a dream with only uboot on the sd card , But I`ve found that my 512 gb drive will not boot with only the...
I build and fly quadricopter / hexacopters and the udoo would not be my first choice . Why because of the first rule , keep the weight and power...
Which side the sam / arduino or imx6.?
People can just get confused about how to set up a working network , because it can become quite a complex subject , and we really don`t have the...
Didn`t know about the 8.8.8.8 google nameserver server , so I guess that`s something new for me , I use the opendns nameservers at :-...
Yes , I took and passed the ccna too ( 2010 ) , plus the network + , msca etc etc etc. ( What can I say I was bored , now sick of all things...
The way I compile is native , eg compile on the udoo it`s self which is a lot slower , but you don`t need any toolchain etc. So : make -j4...
Sorry I may be confused what you are asking , BUT you are wrong with the statement below. First I will check we are on the same page ....
The jumper near J1 is in place right ?. correct baud rate and coms port ?. check your psu for voltage drop ? After that no idea , but sound bad...
If it`s not getting out of your router it`s not a dns problem it could be the default gateway address. DNS resolves a domain name into a ip...
setenv is a part of uboot , so if you can use any linux command then you are not in uboot . Connect to the micro usb socket cn6 , power on and...
Separate names with a comma.
