I said that flashing goes OK outside and inside! PC can read data, but sometimes Linux imx cpu blocks transmitting data from PC to arduino......
Well... actually it doesnt erase flash it just blocks sending data from PC to arduino but it is possible to receive data from arduino to PC UDOO...
Hello all... I have question how to rotate HDMI? i have lcd panel over hdmi and i need to rotate it upside down i will say that xrandr cant do...
Strange but UDOO blocks sending data from PC to Arduino I recompiled kernel with usb_gadget_serial support (rather thatn usb ethernet) and use #...
Recently i had problems using eGalax usb touchscreen To be able to use it you must recompile kernel Heres also little tutorial how to compile...
But i can surely do ECHO test from linux miniterm.py -p /dev/ttymxc3 -b 115200 any suggestions?
I thought that problem is in RepetierFirmware but no.... i made testing script: byte byteRead; void setup() { // Turn the Serial...
Well as im using repetierfirmware i noticed: arduino send data to PC data from PC also goes to arduino BUT! but arduino dont receive commands its...
I have such problem only with RepetierFirmware i tested firmware ASCIITABLE and it works every time (doesnt erase)
Thanks for replies Yes i know that there is jumper But it is very strange It behaves like after power on it erases automatically There is PIC10...
Do you also have such problem?
At schematic i see that arduino restarts when udoo restarts there is also IC called PIC10F200T(which get data from uart) which goes to Erase pin...
Yep it behaves like it is erased i reflash and it starts to work is there any pin from udoo which erases arduino?
Hi all... I dont get it When i start udoo (powe on) every time arduino stops to function (like freezes or dont even boot) seems like it erases...
try to run command: #depmod
Yep it is in ideal case i am using official image+kernel after boot some pins are outputs,some are inputs (dont know why!) so i make bash script...
OK i got it... i got patched arduino ide from UDOO web site and i can flash arduino now but i also need to set all udoo pins to input, how it is...
Hi all! I really need to use just Arduino Due But without SD card it is flashing one pins and it sets all pins to HIGH... How can i program...
How to connect ordinary RGB LCD?? For example 24 bit rgb lcd? Must connect to arduino pins?
Hello all! how i can connect ordinary rgb lcd (24 bits+sync..) to udoo?
Separate names with a comma.
