No it doesn't have onboard wifi or bluetooth.
Those are the standard US wiring colours, strange but true. 13A fuse is not appropriate, it should always be a lower rating that the wire, so 5A...
Nice.
Thanks. Just an underscore instead of a hyphen.
That page has this line "If you are one of the Kickstarter users and you see a Green Dot on one side of the fan, please check the Fan Settings...
Thanks but I don't see the schematics there that were linked to above. It says "Heads up! Other files, like the schematics of the board, will be...
Why do I get connection refused for download.udoo.org?
Thanks. It looks like I can get the positions from the STEP file with FreeCAD. I model with OpenSCAD so I can't just import STEP.
Are there any dimensioned drawings with the connector layout, fan positions, etc. I want to design a case for my Bolt but all I have found is a...
I always spread the paste with a blade to a thin layer all over before assembly. I don't rely on it spreading itself.
The internal fan blades would spin if you blow air over them. It would be better to replace it with an open duct. It could be made from the...
I think the problem of fans not starting is nothing to do with the BIOS, they are simply faulty fans. The BIOS update is to make it less noisy by...
The circuit is obviously designed to drive a 3 pin fan with PWM. The capacitors will then have little effect because the current taken by the fan...
The CN7 PWM signal is designed to switch the supply voltage to the fan. It has capacitors on it so it wont work as PWM for a signal pin and...
Yes a resistor to ground but I would go for something between 100 Ohms and 1K because it has to ensure it will go low despite there likely being...
If the fan spins at full speed when the PWM line is disconnected that means it has a pullup at the FAN. The Bolt fan output is designed to drive a...
What happens if you connect the PWM pin to ground? I would expect it to spin 100% with the PWM pin floating. Perhaps you need a pulldown resistor...
I don't think you will find one advertised as a 3 pin PWM fan. As I said all fans can be PWMed but they will wine or stutter as you describe. That...
I come from the 3D printing community where it is common to control 12V 2 or 3 pins fans with PWM. 4 Pin fans are quite rare and even old PC...
PWM isn't the same as changing the voltage. Reducing the voltage reduces the torque until some point where the electronics stop working. With PWM...
Separate names with a comma.