These are well said comments. I posted something similar in the Android for Neo thread but with no response. This is my visit to the forums after...
The problem you are encountering may be because 'video_output' needs to be set to lvds7 in two different places (/data and /system). See the...
@Andrea Rovai When will motion sensors be supported in Android for UDOO Neo? Does any camera functionality work yet? I found a connector from...
@Andrea Rovai Thanks for the update! I used the info in the link from March 24th to build with GPS enabled. Seems like some other users are...
I have the current 5.1.1 alpha running on LVDS 7" display w/ touch support. Wifi, Ethernet, and USB host are functioning and stable. adb works...
Oh, I see. There is a setting in the Settings panel of the running Android system. So an HDMI monitor has to be hooked up to change to LVDS display.
At run-time or build-time? How are the system settings configured? Pardon my lack of knowledge regarding Android.
@Francesco Is lvds display output controlled only by editing 'device/udoo/udooneo_6sx/uEnv.txt'?
Oh, right. The cross compiler is controlled by manifest. I downgraded make from 4.0 to 3.81 based on Android build requirements page, hopefully...
Which version of gcc/g++ is being used successfully? I'm getting a lot of 'internal compiler error' while using gcc/g++ 4.9.2. Restarting the...
@Andrea Rovai The release notes say that LVDS is working. Any hints on how to make use of it?
There's an alpha level release from UDOO for the Neo in the Android section of the forums. If you are going to start from somewhere, might as well...
@Pilif You need more than status = 'okay'. Either enable in dtweb on Udoobuntu RC1, or fiddle with patch to dts that I posted in uart6 thread...
Good. Sounds like you are almost there. * arch/arm/boot/zImage from the build goes in /boot (there's already a zImage that you probably want to...
Use UART6 for external sensor/etc. by enabling it in dtweb (Udoobuntu RC1). But there's a kernel patch to apply, see the following post for...
No problem, I'm glad to have this one solved. Pull request has been submitted.
I couldn't get UART6 working, even after reflashing to a fresh RC1. After a friend pointed me to this post in another forum,...
What is the best way to use VADC without the mating connector? Solder directly to the board?
This is in RC1 drop? Is there any way to get the new dtweb functionality without doing a from scratch SD card flash? I have the latest kernel,...
I see the same overrun error when trying to using UART6. Interestingly enough, I first ran into it the same day that 1chi did. But I was able to...
Separate names with a comma.
