Quick answer is yes the pads are on the bottom of the board , I have 2 Jlink's my old one only the A9 core but the newer one (about 12 months old)...
Hi Maurice sorry for delay been a bit under the weather Sda Scl are th i2c bus standard developed by phillips nxp now the scl is a clock and the...
The more i look the different libs the more they look like a slowed down i2c maybe try talking to on the I2c pins after all the sda pin does look...
Maurice have you tried reinstalling the os so the SD card so it cleans everything up if its not playing at all now.
doesn't sound like if its hanging on a straight for digitalwrite sounds like some corruption to the system maybe are you working on a pc and...
Hi Maurice The display looks like the i used a while back and i was a bit touchy on timing in my case i was using an arm 9 clocking at 400mhz and...
Hi Maurice sounds like a timing issue the display library is probably bit bashing the clock and data and doing something else will cause them to...
Ayeed Rpm can be measured a couple of ways you can use a incremental encoder which is attached a shaft directly coupled to engine these tend to be...
The Neo performance is fairly good in comparison with other equally equipped boards on the linux side it is slightly faster than my Pi B ,...
The input pin will see 5v when the switch is closed unless the switch has a high impedance which would make it a very poor switch. The weak pull...
Maurice it looks like an error in the book big warning on the UDOO features page http://www.udoo.org/features/ and also in the nxp data sheets...
Hi Maurice not sure why it is in the udoo book as i'm pretty sure the i.mx6 devices aren't 5v tolerant and the udoo doesn't have a level shifter...
The uno has 5v logic io which is the reason they connect to 5v , using 3v3 will work fine for the udoo don't use 5v directly to a udoo io pin or...
Couple of things to look at firstly is there an unknown device showing up in windows device manager if so that is probably the udoo. if not is...
plexi47 The device theybare using is a module from TI they have a linux driver for the beagle bone and the full sdk...
i'd be surprised if it was as high as 150ma , NXP don't seem to publish them for some reason but there was a thread in the neo section which may...
Thanks Andrea look forward to trying it out
after reading David wang post which is in fact the way to go. I started to ask why you need to modify these libraries I have an Intel Galileo and...
i would aim for the Standard libraries here once these are in most of the adfruit seedstudio and sparkfun libraries work out of the box...
Thanks for the update Andrea.
Separate names with a comma.
