I don't have my board with me this weekend. I'll try the image on Monday and post the results.
I'm cross compiling using an Ubuntu 14.04 image running in a VM. I had tried installing the too chain earlier and gotten the same error as...
OK, I want to use the Vin/Gnd without the barrel jack, which is working great! Thanks.
Using Vin/GND pins on the inner header I've powered the board using 6V, 7V, and 12V (5V did not power). I've powered the board using the micro...
Yes, no problems.
Yes, I've powered it up using 6V, 7V, and 12V. It would not power up at 5V. I've been using 12V for a couple of days with no problems.
Through the USB connection: >ssh udooer@192.168.7.2 $ minicom -D /dev/ttyMCC ctrl-A q to quit minicom
It doesn't boot at 5V but it does at 6V and above (I tested at 6V, 7V, and 12V). Thanks.
No power light. I'm using a programmable power supply set at 3.3V output with a max of 2A. It shows no current draw.
What is the max voltage for VIN? 3.3V? 5V?
The Udoo Neo doc pages in Power Management have: Power sources You can power up the board in 3 ways DC-jack: internal positive, Voltage 6 to...
I have the same problem: sudo dpkg --configure -a Setting up dtweb (1.13) ... Removing dtbkernel... 3 /var/lib/dpkg/info/dtweb.postinst: 13: [:...
The above thread did help me find the missing udooclient and fix the problem: In folder /Users/<user>/Library/Arduino15/staging/packages, I found...
I want to program the Neo M4 from my Mac (El Capitan) using the Arduino IDE v1.6.9 over the network. So, I followed these directions...
The Neo Doc under Arduino M4 Processor, Arduino differences says: UDOO Neo M4 Processor has 2 I2C buses wired to the pinout headers and...
No, Wire1 did not work.
The below code to detect I2C devices (MCP3424 ADC) on arduino like micro-controllers works perfectly on an Arduino Uno R3 and a Teensy 3.2, but...
I do not have a brick sensor connected. The 0x6F went away, so I must have made a mistake in my code running on the M4. I am curious though, why...
When I run > sudo i2cdetect -y 1 I see a device driver loaded at 0x6f. I would like to add a device that uses that address. Can I remove the...
OK, it appears to work now. For some reason the I2C scanner code from the Arduino site does not work on the Neo. Thanks for your help.
Separate names with a comma.
