The issue only seems to occur when using minicom. If I access the serial port through a c program it works fine.
I've uninstalled the udoofota-serial package using 'sudo apt remove udoofota-serial'. But I'm still seeing the serial data in my remote Arduino...
Could the issue be that I also have the udoofota-serial package installed? Will there be a conflict? The serial comms looks fine when I monitor...
SimpleTimer is just an arduino library for scheduling tasks. I don't think this is the source of the problem. I have simplified the code so that...
That's what should happen. But it's not. Instead, the LED is turning on and staying on.
I'm experimenting with the serial communications between the A9 and M4. I have the code below running on the M4, and on the A9 I am using minicom...
Correct me if I'm wrong, but isn't the serial.available() method for checking if there is any data sitting in the receive buffer? In my case the...
I was having the same issue when writing to the hardware serial port (Serial0). It worked ok after programming from the Arduino IDE, but nothing...
After updating the OS it is working.
I just tried running a simple "hello world" sketch. It still doesn't run automatically on power-up. I'll try updating the OS later.
Thanks, I will give this a try tomorrow.
I am using an Udoo Neo programmed from a PC. Setup is as described in the 'getting started' section of the docs.
I am launching the sketch from an external PC. I'm pretty sure my board used to run the sketch automatically each boot, but it's not doing it...
My Arduino code only runs when launch it from the Arduino IDE. How can I make it run every time the board it powered up, without having to launch...
I had to change a line in the readReg function to get it working; Before: Wire1.endTransmission(); After: Wire1.endTransmission(false); With...
I've been into the Device Tree editor, right clicked on the I2C-4 pins in the right panel and removed them. Then I saved the config and rebooted....
Thanks for the reply. I haven't done this step. But I was able to run the example gyro code without doing it. Seems strange that the example...
I thought I would have a go at rolling my own interface for the gyro. Unfortunately I'm having trouble getting the I2C working. Here's a snippet...
Thanks for the links
Is there an Arduino interrupt-based timer library available that will work with the Neo? I need to be able to run a function at precisely-timed...
Separate names with a comma.
