No i don't found my solution, i have the last release 2.0.2 and no found since ...
TU waltervl, I take a look in that link (but for me, lock up requiring a reset, appeared before access IMU)
I use standard library not added others.
Hi all, My Udoo freezes after a few minutes of good operation. Is there an arduino supervision software? or supervision software via Braswell? I...
For sure :-)
In conclusion, it is necessary to read USB port side Braswell before genuino soft side start ...
I don't understand, when i add CurieSoftwareSerial, only SoftwareSerial.h file is added !!! It's the same library that SoftwareSerial choosed !!!...
Idem, virtual uart stop working at 20' :(:(:(
I tried with less speed on virtual uart (pin 9 & 10) , i send a string with 32 characters all 100ms. At 19200Bds, worked ok during 23' Now i...
Another test without CurieSoftwareSerial lib but replaced by uart build in one work fine.
The one i created with CurieSoftwareSerial. But for this test, i didn't use interrupt, only this virtual uart in Rx ....
Yes I use that library, but after any minutes, uart stop to work without know why ???
Not possible for me, I used UDOO ULTRA board with genuino 101 embedded .... I tried too NeoSWSerial lib but it doesn't work with my MCU !!!...
I tried to use SoftwareSerial.h librairy but il doesn't work in my case, because i have a lot of gpio interrupts and full duplex on uart...
OK, I already use Inside USB port and outside uart genuino port. I will find another solution. Thanks
Hi all, I just seen that there is one USB port on Genuino 101 board alone. Is this USB port exist on arduino side in UDOO ULTRA Board ? If YES,...
OK, I don't know why, but now it's working !!! TU
I just tested with BLINK program and it working after a OFF then ON power !!! Here is the beginning of my sketch : void setup() {...
Yes, the sketch I have loaded before to the curie is not running after a start or restart/reboot of the complete Udoo X86. In fact, after others...
Hi all, When i power up my UDOO ULTRA, the currie soft don't start. I have to launch the arduino IDE then the terminal for this app to start. I...
Separate names with a comma.