@nophead I am no electrical engineer and have only a very rough understanding of these things... But does that mean, I should put a resistor...
@nophead: If I connect Noctua +5V (yellow wire) to Arduino +5V, Noctua GND (black wire) to GND and Noctua PWM (blue wire) also to GND, the fan...
Even after setting to default values and rechecking the wires, when following @Zgembo 's instructions, I have a fan that is always on. In fact,...
Even after updating to Eva's linked BIOS, the Noctua fan keeps spinning, even when the Bolt is switched off. Must have done something wrong......
I just bought the NF-A6x25 5V PWM and tried the described setup. In my case, I wired Noctua -> BOLT black -> black (GND?) yellow -> ** Arduino...
Separate names with a comma.
