Ok so I have a pretty simple ROS arduino sketch that requires a couple libraries that arn't too large. I'm trying to avoid having to have a...
Hello, I have an UDOO x86 Ultra with Ubuntu 16.04 and I installed the Arduino IDE 1.8.9. The internal connection to the Arduino/Genuino 101 is...
Hello All, I am using Udoo X86 Ultra for my application. I successfully installed Ubuntu16.04 on eMMC memory of Udoo. And also successfully...
Hello! First off, I'm a software engineer. I don't do hardware! As you can see, I can't even fade a LED... I am trying to run the "Fading"...
Hello, Do you know what's this pin? Can it be use as input or output ? Thanks
Hello, I have recently noticed that I am unable to set a HIGH voltage on GPIO pins 8-15 on the Arduino on my UDOO x86 Ultra. The code I am running...
I started working on UDOO X86 advanced board recently and made it dual boot. I installed Ubuntu 14.04 in internal 32GB flash memory while...
Hello, I have seen the post : https://www.udoo.org/forum/threads/wake-and-sleep-via-arduino-101.9237/ I am using linux, do I just need to do...
Hello, I would like my arduino 101 to switch on or off leds depending on the network state wifi,bluetooth and ethernet. However I don't know how...
Hello, I am having an issue with my udoo x86. I was uploading a sketch to the arduino 101 and I accidently switch off the power. When I powered...
Hello, I would like to know if it's possible to automate a communication between the Braswell and arduino 101 without using the serie monitor. I...
Hello, I am wondering if my arduino 101 is dead. I power my udoo x86 and detect the arduino 101 with the arduino IDE. I can send code and use the...
Hi everyone, i'm running ROS on Linux Mint on the UDOO and in addition to publishing my data in the ROS-environment, I also want to feed it to the...
Hi i finally got me a udoo x86 ultra. it should arrive this week :D im very new to all this arduino stuff, i just finished my first arduino...
Hello, I'm hoping someone can help me out here. I've searched the forum and followed the other answers that I've found to no avail. What I...
Hello All, I'm trying to program my X86 Advanced Plus to wake and sleep via an interrupt using the Arduino 101 interface. I have successfully...
Hi guys I plan on to buying the UDOO x86 board for a project and I was hoping if anyone could tell me if it is possible to run multiple arduino...
Hi there, I'd like to know if it is possible to control the GPIO states on Windows 10 from command line (or batch file)? Kind Regards,
I can't upload sketches from the Arduino IDE (1.8.4, Windows 10 x64) to the UDOO X86 Curie. I have installed the BIOS version 1.03 on the UDOO X86...
I'm a little confused on the documentation for the UDOO x86. For the arduino pinout information, it says that the digital I/O pins are 3.3 V, and...
Separate names with a comma.