Hello, I want to control the energy of USB3.0 and Arduino Leonardo processor on the Udoo Bolt V8 board. When I turn off the pc with the power...
It took me a while to figure out how to get readings from the on-board IMU sensor, so I'll share the code I used, made with the fastIMU Library in...
The campaign page says you can use the Arduino ide but all I can see in the documentation is using linux or for the esp32 using esspresifs tool....
I just picked up an Intel Coral USB Accelerator ($59.99) from Mouser (after waiting a few weeks) for exploring Machine Learning and object...
Hello, I try to use Udoobuntu as OS in a UDOO neo board to use it as an Arduino. I try a day long to boot the OS without success. I have always a...
Hello to everybody, I am wondering if with any of the UDOO boards is it possible to run Arduino code in the background when the UDOO is plug to...
Dear all, as titled. Thanks!
I am running a simple script on the Arduino that is supposed to output to serial (/dev/ttyACM0). It works great in the Arduino IDE and can even...
Hi, I tried to search for this, but didn't find a good answer. Does the Udoo Neo arduino controlled pins have internal pull-ups that can be used...
I am attempting to run a sketch on my Udoo X86 built-in Arduino using the Arduino IDE. After opening the IDE, I enter in the sketch and attempt to...
Hi, I'm working on getting the arduino in the UDOO to talk to a python script. I have successfully loaded the example serial library script to...
Hey, We are trying to get a higher resolution PWM from the Arduino side of the Udoo NEO FULL. On a normal Arduino it is possible to change two...
Hello, I'm having a problem selecting the serial port to upload a ketch to the internal Arduino. When I try to select Tools->Port, the voice is...
Hi! I will start a project where is necessary the bluetooth communication and I have some questions: 1.- It's possible the bluetooth...
Hi guys, I am developing some project with FreeRTOS BSP for iMX6SX on my Udoo Neo Full. My project used a lot component from FreeRTOS BSP such as...
Hi there! I am using my Neo as an openhab2-server which works pretty well. There is a sketch running that controls a 433 MHz sender to control...
Hello, I use the Udoo x86 on Ubuntu 16.04 and I realized it takes 7 seconds for the curie to power ON. Then it stays turned on for 7 seconds and...
Hello, Is it possible to power only the intel curie processor (arduino) and not the Braswell processor by supplying 5V on the pin 9 ? Then if I...
Hello, I am having an issue with my udoo x86. I was uploading a sketch to the arduino 101 and I accidently switch off the power. When I powered...
Hello, I have seen this website : http://www.geduino.org/site/archives/284 It explains how to send data from an arduino to the udoo x86. However...
Separate names with a comma.
