When I first power on, the screen is black for 8 seconds and then an underline cursor appears. The computer sits idle like this until about 1...
I have a Kickstarter UDOO BOLT V8, needless to say it's been in its box a while. I have BIOS V1.04 and a green dot fan. It boots the BIOS fine and...
Hi there, I use the Bold Gear with the included Power Supply but for any reason the system does not boot. I see the power LED get green then...
I have 2 UDOO x86 boards installed in machines that are used in agriculture. These machines are situated in very remote areas. One of the boards...
Hi there, I upgraded the UEFI BIOS to version 1.06 as described here. As shown in the UEFI Shell console, t seems that UEFI BIOS 1.06 is based on...
Hi, I have installed Ubuntu 16.04 on my 32GB SD Card and tried to use it with my Udoo x86 board. However it doesn't boot into the OS, I get the...
I'm unclear why this M.2 drive is not listed from the BIOS as a bootable device. Windows 10 allows me to install to it, but when it comes down to...
Hi all, I have gotten close to getting my autopc with the X86 up, there's just two small problems. First, Windows wants to set my res to high for...
Hi everybody, I have an issue with my Udoo Quad. I used it without problems for a lot o months then I shutted it down for a couple of months and...
Hello. An unfortunate sequence of events (beyond the scope of this thread, but involving glitches while using dual DisplayPorts, Ubuntu 17.10...
The small boot image mentioned in the docs, qdl-sata.img.zip, is not there at the end of the link (tried wget). When it is there, is it valid for...
Hi There, I've had my UDOO x86 Advanced for a few weeks, but only recently took delivery of the PowerSupply from the UDOO store. On powering up...
When I insert a 128GB SD-Card in a USB card-reader (with a Debian Jessie live image burned on it) into a USB3 port, and apply power, all I see is...
I think the LVDS is the default video output right? Can I change it to HDMI? I have a bootable thumb drive and sd card but I don't know what...
Hi everybody! I installed Ubuntu 16.04 from usb, and everything seemed to work well, but after the reboot needed by the installation Ubuntu won't...
My Arduino code only runs when launch it from the Arduino IDE. How can I make it run every time the board it powered up, without having to launch...
Hi@all, I am new to udoo, have some experiences with Raw Arduino's (uno, micro), Rasperry PIs and working with Microcontrollers as a hobby since...
HI, I tried everything to got the sata working with the Quad Udoobuntu 2.0 RC2. I tried it as explained in the manuals, both ways: for the...
Separate names with a comma.