Hello, I am looking to use the UDOO Bolt as a DCS controller with a GUI running in Linux. My system communicates over a CAN BUS network. Up to...
Hi, My first post in this forum. It is nice to be apart of the UDOO community. My question is about a MCP2515 module board. This runs over SPI. I...
Hello, I am currently having issues getting UDOO's flexcan working. Following is the yocto build configuration i am using. (meta-udoo krogoth...
Hello guys, does the UDOO x86 has support for communicating over can bus? Does it has a transceiver or controller for can protocol communication?...
Hi All, I've been working on developing CANopen communication using the inbuilt CANbus and additional transceiver units on an Udoo Neo Full. Got...
Hello, I just got couple of Neo Full boards and these SN65HVD230 units. I would like to capture in this thread about various steps and...
Hi I cannot find the can bus ports for the arduino due on the udoo quad pinout!!!!!! where can i find the pinout ?
Separate names with a comma.