In a previous post https://www.udoo.org/forum/threads/using-braswell-gpio-i2c-and-uart-pins.32423/ I discussed the use of the libgpiod library,...
Section 3.3.13 in the Bolt manual describes all the pins but I'm failing to find how I access them from the OS. I wanted to see if I could make...
Hello, In the udoo x86 II documentation [IMG] GPIO 492 and GPIO490 i think they are in wrong places.Because i exported pin number 492 and set...
Hello, I have 2 question about udoo x86 II Gpio's pins. 1)How can i set the default value's (when start udoo all gpio's pins at HIGH state 1.8v)...
I am attempting to run a sketch on my Udoo X86 built-in Arduino using the Arduino IDE. After opening the IDE, I enter in the sketch and attempt to...
I would like pins 20 and 21 to be used only for I2C. I used the device tree configuration tool to enable I2C on these pins and I2C seems to work...
Hello, I have encountered this issue on two separate and new UDOO x86 Ultras so I don't believe it is from board damage. When I set GPIO pins, for...
Hello, I have recently noticed that I am unable to set a HIGH voltage on GPIO pins 8-15 on the Arduino on my UDOO x86 Ultra. The code I am running...
Hello, I got my UDOO X86_64, loaded with Fedora 27, and I am trying to work with GPIO pins. I should also mention that I have never worked with...
Hi to all, I'm trying to integrate my Udoo with Openhab2. The GPIO binding seems to need export/import echoing working but in my case it...
I'm trying to attach an interrupt to a GPIO pin, so it is fired when i press a button, which action is to toggle a LED. Code is run on my...
I have been using the example in https://github.com/kamejoko80/my_osek/tree/master/NEO_M4_BARE_METAL to set a led on/off. It works, but now i'd...
Hi, We have a Rover project powered by a Raspberry Pi 3 / Windows IoT Core which works well but we need more compute power. We control the...
Hi there, I'd like to know if it is possible to control the GPIO states on Windows 10 from command line (or batch file)? Kind Regards,
Hi! I bought a "Udoox86 advanced" and I want to reuse my Adafruit's sensors . In particular this one: https://www.adafruit.com/product/1362 How...
Hi All, I have a 7" Cap touch display that is LVDS and I2C. The controller board converts the LVDS and I2C into a GPIO pinout. The display link...
Does anyone have instructions on how to setup the pinctrl driver to access the Braswell GPIOs from LINUX? I have searched the forums and the net...
I am thinking of writing some app on ODOO x86 which needs to access SPI port based on hardware interrupt on GPIO is it possible to do that in Win 7.
The issue I am having is, I was working with a circuit that was connected to a 12v power source and it may have short circuited... Before when I...
Separate names with a comma.