hardware

Thread

Hello Udoo neo board powered by 12v 2A power adaptor 7" HDMI display's hdmi and USB directly connected to the board. I used uDoobuntu 2.3.0...

Thread by: hiten, Feb 17, 2020, 2 replies, in forum: General Discussion

Thread

Hello I used uDoobuntu 2.3.0 (ubuntu 14.04 LTS) prebuild img from https://www.udoo.org/downloads/ and I have hdmi display which is look like...

Thread by: hiten, Feb 13, 2020, 5 replies, in forum: UDOO NEO

Thread

Hello, I have udoo neo board with android source code now I want to read udoo neo board temperature how I do it ?? Or is there any temperature...

Thread by: hiten, Feb 6, 2020, 1 replies, in forum: UDOO NEO

Thread

hello, I want to try the interface thermistor sensor at A0 pin on udoo neo board and try to get data from...

Thread by: hiten, Dec 24, 2019, 6 replies, in forum: UDOO NEO

Thread

I am trying to use the physical UART pins on an Udoo x86 running Windows 10, but they are not working even after following the driver install...

Thread by: David Schurman, Jul 15, 2018, 3 replies, in forum: UDOO X86

Thread

Hello, I have recently noticed that I am unable to set a HIGH voltage on GPIO pins 8-15 on the Arduino on my UDOO x86 Ultra. The code I am running...

Thread by: nhenault, Jun 12, 2018, 0 replies, in forum: General Discussion

Thread

I ran across the PINE64 site today, and was surprised to see what look like additional i2c "brick" modules available. I don't know that they are...

Thread by: LDighera, Jul 17, 2017, 3 replies, in forum: UDOO X86