Hello, I want to control the energy of USB3.0 and Arduino Leonardo processor on the Udoo Bolt V8 board. When I turn off the pc with the power...
Hello! I have 20 Udoo Bolt V3's that I am using in some arcade cabinets. The manufacturer building the arcades has them now. Several of the units...
Is there any setting in bios or otherwise that can allow two power sources to be connected at any time. Id like to have it connected with DC power...
Hi. I`m new to sbc world and electronics in general. And want the udoo to be my first. Been reading past post on the forum when people asked the...
Hi all, I'm going to add an external graphics card to my V8 and have an extra PSU for that, but I was wondering if anyone has adapted either the...
Hello, I'm looking to turn my Udoo Bolt into a NAS and I was wondering if the 1.06RC or 1.07 BIOS updates have fixed the issue where the Bolt...
Hello, in the manual is says Idle, power saving configuration OS Boot, power saving configuration Video reproduction@720p, power saving...
Hello, First post on this board. Is it possible to read the input voltage coming into the board without adding 2 step down resistors and a...
My system Udoo is great running "Unbutu". Due a test with Arduino the system lose power just for Arduino-Curie. Unbutu and all other function are...
I'm trying to make a portable device with the Udoo and I can't use the wall charger to power the Udoo. What alternatives do I have?
Hello, Is it possible to power only the intel curie processor (arduino) and not the Braswell processor by supplying 5V on the pin 9 ? Then if I...
Hello, When I power my Udoo x86 there is a led flashing from green to orange. I noticed that it's doing it until I reach 12,4 V. Also below 12,4V...
thinking about replacing my raspberry pi 3. does anyone know how many watts or how much current does each module consume? thanks.
I'm building a mini cluster using a single external power supply for all the boards. All the boards power on immediately when I switch on the...
I looked in the manual, and searched the forums here, but could not find the maximum allowable power for the fan connector. This bit of...
Hi I did some measurements to determine the power consumption of the UDOO x86. You might find the results useful. Setup System: Udoo x86...
Separate names with a comma.
