I have set up the UDOO motherboard with Windows 11 last week. But I am encountering a problem when I am trying to install software. Every time I...
Hello! I have 20 Udoo Bolt V3's that I am using in some arcade cabinets. The manufacturer building the arcades has them now. Several of the units...
Hi all! I am using a fleet of UDOOs in a headless manner and, upon provisioning, I update the BIOS boot settings to switch over to "Legacy" boot...
Hey guys I am trying to power up my Bolt v3 with "Lenovo 65W 20V 3.25A Standard USB Type-C AC Adapter Charger - 4X20M26274" I am using no...
Hello, I have 2 question about udoo x86 II Gpio's pins. 1)How can i set the default value's (when start udoo all gpio's pins at HIGH state 1.8v)...
Hi there dear fellow Udooers! I am currently designing the case for my becoming Udoo Bolt v8 board. However, since my board is still on shop and...
Udoo bolt seems to be a great board but currently the fan is noisy Have you the same issue? My board's fan start/stop regulary however the rad is...
Hi , I want to pass kernel enable or disable parameters (Selinux enable or disable) at kernel boot time ,So want to pass those parameters from...
Hi , we need a udoo neo supported ubuntu 16.04 img ,because in 14.04 some tools and packaged are not supported .So please provide udoobuntu 16.04...
Hello, We would like to install Asterisk 11+ on the QUAD ARM Udoo card but we can not install DADHI, a component that is used for conversations...
Good Day Udoo forum members, I've been thrown in a situation where a well-vetted & recommended Electronic Engineer in my region created a PCB for...
Hi, My first post in this forum. It is nice to be apart of the UDOO community. My question is about a MCP2515 module board. This runs over SPI. I...
Hi, We accidentally turn of display ports in BIOS, and later power on we can't see anything on HDMI monitor? any idea how to recover an get the...
Currently have Ubuntu 16.04 installed on my UDOO X86 board. It is currently running kernel 4.15. I wanted to update the kernel but ran into some...
Very basic question here, that I am hoping has an easy fix. I have a UDOO X86 Advanced board running the Ubuntu OS. I have purchased and connected...
Hello friends. I set up the system correctly. Partly for sure. I tried to boot from the flash memory. I failed. I also tried to open the Boot...
Hi all, My Udoo freezes after a few minutes of good operation. Is there an arduino supervision software? or supervision software via Braswell? I...
I have a udoo installed in a remote location and sometimes there is a scenario when: 1. There is a power loss. 2. When power is restored, Windows...
I am trying to run the example rpmsg echo from freertos 1.0.1 from nxp. I actually know that rpmsg ins not supported in the current kernel, but it...
Hi, Is it possible to connect other I2C sensors (in my case a BME280 from Adafruit) to the I2C of the brick? Is there somewhere a description what...
Separate names with a comma.
