[8 Mar][6dq/6sx] AOSPMod MM-R.07

Hi @herionoindo,
strange: audio should also work "onboard". After you've set the output to "onboard" beware to reboot the board as said here, and if the problem persists update this thread please.

 

It's all in the docs, there's a specific section for this here.

 

@Andrea Rovai i was setup output audio, but i still can not hear anything when play music. What else?

 

Hello.
First - Thank you for the mod.
Next:
I try to change hdmi resolution with following command, that shown in docs
setenv bootargs console=ttymxc1,115200 init=/init video=mxcfb0:dev=hdmi,1366x768M@60,if=RGB24,bpp=32 video=mxcfb1ff video=mxcfb2ff fbmem=28M vmalloc=400M androidboot.console=ttymxc1 androidboot.hardware=freescale mem=1024M
and next write boot and press enter.
After that android won't boot and I got following error in console:
[ 4.940644] android_usb: already disabled
[ 4.945197] mtp_bind_config
[ 4.948239] init: write_file: Unable to open '/config/usb_gadget/g1/configs/b.1/strings/0x409/configuration': No such file or directory
[ 4.960518] init: property 'sys.usb.controller' doesn't exist while expanding '${sys.usb.controller}'
[ 4.969782] init: cannot expand '${sys.usb.controller}' while writing to '/config/usb_gadget/g1/UDC'
[ 5.696703] binder: 159:159 transaction failed 29189, size 0-0
Last line is repeating forever.
What I did wrong?

 

Also. I tried to install gapps, register google account and figured out that performance is terrible. Installation of Google maps tooks several minutes, aps often freezing and so on. (((

 

@Andrea Rovai any way, how to change over SETENV command?

 

You have to connect via serial. There's a part about it in the docs: http://www.udoo.org/docs/Basic_Setup/Connecting_Via_Serial_Cable.html
Once connected in serial you must use uboot commands to change the SETENV

 

Ok guys, it's time for updates! Look at the first post.

Have Fun!

 

First post updated.

Have Fun!

 

First post updated.

Have Fun!

 

First post updated.

Have Fun!